• 5GHz_pa.jpg
  • class_a_pa.jpg
  • dds_header.jpg
  • diamond_6m_header.jpg
  • filter_header.jpg
  • iss_ham_radio.jpg
  • mapping_header.jpg
  • resistor_header.jpg
  • rg213_header.jpg
  • rigol_header.jpg
  • shure_header.jpg
RSS
Back
2013 Transit Connect. Luckily It was already ply boarded.
2013 Transit Co...
Grille bulkhead with gate for long loads. This was no go as I wanted my rack and desk at the front.
Grille bulkhead...
I fitted a steel bulkhead and asked my son to make me an operating desk to fit the bulkhead profile. My desk includes a 19” rack and shelves.
I fitted a stee...
Rear view of the desk unit.
Rear view of th...
2metre DATV PA assembly. Includes broadcast class A amplifier, antenna switching and filters.
2metre DATV PA ...
Nearly completed. Just needs handles fitted and a soak test, the amplifier is a 15Watt pallet.
Nearly complete...
Work in progress. This was assembled in a used enclosure; I overlaid the old front panel.
Work in progres...
Combined 13cm/70cm power amplifier enclosure. Early stages working on the 70cm section.
Combined 13cm/7...
70cm plumbing. Useful when you can use existing holes; or slots in this instance.
70cm plumbing. ...
Left side is 70cms. Power amplifier, heatsink and fan now in; front panel almost finished.
Left side is 70...
Twelve Watts at 70cms. First test and all is working as it should.
Twelve Watts at...
MiniTiouner test. I connected the tuner to confirm the relay was switching OK.
MiniTiouner tes...
Finished at last. No pictures of the 13cm section but it's based on a 2.5 Watt class A Continental microwave amplifier.
Finished at las...
Loads of changes. New bulkhead, rubber floor covering, 110AH battery, Honda generator, extinguisher and desk.
Loads of change...
Impatience! Had to pop out for a quick test so threw some kit in.
Impatience! Had...
Cubby holes. Above the desk I have storage but it's unfinished at the moment. Some aluminium trim is needed to prevent stuff sliding out while on the road.
Cubby holes. Ab...
View from the side door. Kit temporarily thrown in so too many cables dangling about. Hopefully it will be tidier when finished.
View from the s...
Dunstable Downs. My local hill where I took the van for a quick 2m DATV test.
Dunstable Downs...
A still day. No guy ropes needed on my fibreglass mast.
A still day. No...
Ah yes the roof bars. Forgot to mention I fitted those. Conveniently shaped for the Shelley Clamp.
Ah yes the roof...
 
 
Powered by Phoca Gallery